|
 : SERVICES :
WELCOME TO THE SERVICES DEPARTMENT! We specialize in pre-2000 bikes, Evo's, Pans, Shovels, Knuckes etc.
"ALL VALVE & HEAD WORK"
We do general head work, 3 angle valve jobs, clearance checks etc.
"BOTTOM ENDS" (total rebuilds)
"CRANKSHAFT REBUILDING AND TRUING"
"CYLINDER BORING"
"ALL TRANSMISSION REPAIR"
"RIGHT CASE BREATHER HOLE REPAIR"
(before and after)
When the breather holes get scared up then the oiling system will not perform properly. Rather that junk the cases we
can ream it out to fit a new "Jims" oversize breather.
"CUSTOM MACHINING & FABRICATION"
From an idea to a finished product. We can make it happen!
"ALL MOTOR REBUILDS,SPECIALIZING IN KNUCKLES,PANHEADS,EVO'S(pre 2000)"
" LACE AND TRUE ALL SPOKE WHEELS"
Your old spokes getting pitted and rusty or have you rims had just one to many bangs in it. We can help with that.
We try to true our wheels to within 0.010 to 0.020" thousands of an inch.
STRETCHED TANKS & METAL FABRICATION
"COMPLETE BIKE OF YOUR DREAMS (ground up build)"
"TOTAL RESTORATIONS"
YOU NAME IT WE DO IT
Need a new cam or your cam chain tensioners changed in your Twin Cam Models? We can do that for you here. Did you know that most pre-2006 Twin Cams experience cam chain tensioners failure between 20,000 and 40,000 Miles....without warning? When these fail they can make short work of your engine. It is not a major job to have these checked out. This job requires special tools to do the job right without damaging the new installed parts and bearings. Ask us about it when you are here or on your next oil change.Fix this problem, with preventative maintance, before it becomes a very big one.
 
We have now added our newest equipment to our selection of fabrication tools. Our new English wheel and Planishing Hammer. To cool tools. Looking for something custom to set you apart from the normal crowd. Let us fabricate some parts for your custom ride!
 
Something of interest. Making the old New again! Click here
for an example of "How to repair a Knuckle "Head" that had been changed to the Panhead Bolt pattern.
We wanted to change it back to original Knuckle pattern"
PM Cycles Ltd.
7224 Brooklyn Street
Brooklyn Corner, Nova Scotia
Canada, B4N 3V7
Phone: 902-679-2828
Fax: 902-679-0725
|
