"Ground Pounder"

Pics below will open larger.Just click on them!

As winter rears its ugly head once again its time to get down to some welding and grinding. I started this project not knowing where it would take me this time...had some parts and a few ideas.... but no direction. So I just started fooling around with the front fender a bit. Never built a bike with a 16 inch tire up front so I figured it was time to give it a go. As time rolled laong i began to get a picture in my head and then we were on our way. And here it is........the Ground Pounder!!

 

PAGE 1: Got to stat somewhere...CLICK HERE
PAGE 2: Starting the gas tank CLICK HERE
PAGE 3: Eliminating the fuel hole CLICK HERE
PAGE 4: Front and rear fender CLICK HERE
PAGE 5: Make the derbis deflector CLICK HERE
PAGE 6: Oil Tank CLICK HERE
PAGE 7: Gone for paint CLICK HERE
PAGE 8: A visit to Zeke's to check on progess CLICK HERE
PAGE 9: Engine and wheels CLICK HERE
PAGE 10: Oil filter and regulator bracket CLICK HERE
PAGE 11: Oil filter black powdered CLICK HERE
PAGE 12: Frame and Transmission CLICK HERE
PAGE 13: Oil Tank and gas tank CLICK HERE
PAGE 14: Painted fenders CLICK HERE
PAGE 15: Done - Spec SheetCLICK HERE

Don't be sheep.....Be Unique!!!!

RACK

INDEX