Over the years it has been an on going problem of how and where to mount custom signal on wide glide front ends. The Tin Shrouded types presenting the biggest problems. Usually they have a large bar that supports the driving lights and the signals. But many riders like the shroud style but do not want the big bar and lights. And so begins their problems. Also getting them mounted so they do no hit the gas tanks made it even harder.

You probably know or have seen someone who's lights are loosely dangeling from their perch. Hard to mount and even harder to keep tight. We have the solution to all the problems.

With our "Top Fork Mount" type mounts, you simply remove the large top nut of the fork tubes, remove the large washer and replace it with our mount. Then replace the nut and tighten it up. Done!

We also have our "Lower Fork Mount" type mounts. These mount below the shroud and allow for larger or longer lights which may hit the tank with other mounts. These "DO NOT" require you to remove your fork tubes to mount. You simply remove your shrouding panels.

The you take out the two small screws that hold the slider covers on and move the slider down to the bottom fork leg.

Now attach you light to your mount first (as you may need to thread the wiring through the mounting hole before mounting.) Then slide your mount around the tube until the holes line up with the tree mounts.

Slide the slider up and reinstall the srews with the new mount between the slider and the bottom of the triple tree. Put your shroud back on and you are all good to go!

RETAIL: $29.95